Views: 1 | Downloads: 0
The screen printing is a mature technology for preparing thick films and hybrid circuits. The advantages of the screen printing are miniaturization, faster and easier production of complex structures and lower production cost. However, an inherent problem in the preparation of thick-film oxide electronic ceramics could be low green density and hence porosity of fired films and excessive volatilization of volatile components during firing due to an extremely large area-to-volume ratio. In the dissertation the ZnO-based thick-film varistors and the thermoelectric microgenerators (TEMG) made from the n-type (ZnO)5In2O3 and the p-type Ca3Co4O9 materials were developed using screen printing processing.
The screen printing of the thick film varistors shows two critical problems. One is the
high porosity of the thick film varistors after firing , which mainly result s from the low
green density of the films, and hinders their electrical characteristics. The research in the
first part of the dissertation show ed that the increase of the s olids load in the screen
printing ink s improves green density . It also enhances densification and microstructure
development, and results in redu ce d porosity of the films fired at 900 °C for 15 minutes,
which consequently showed also better electrical char acteristics. T he development of the
screen printing inks with high solids load is discussed considering the influence of the inks ’
composition in regard to the used vehicle, amount of added surfactant and binder, and the
content of solids load on the rheology of the inks, their printing characteristics and quality
of the printed films. The formu lation of a high solids load screen printing ink was set and
used for further development of the thick film varistors and the thick film thermoelectrics.
Regarding t
he second problem of excessive volatilization of the Bi 2 O 3 during firing thick
film varisto rs , lower firing temperatures and short firing times are preferred At such firing
conditions the presence of free Bi 2 O 3 to form a liquid phase, which enhance s the
microstructure development is desired . Accordingly, t he second part of the dissertation
shows and discuss es the significance of a proper amount of the Bi 2 O 3 and the Sb 2 O 3 to
Bi 2 O 3 ratio in the starting varistor powder mixture for enhanced electrical characteristics
of the thick film varistors .
In the last part of the dissertation the development of the screen-printed thermoelectric (TE) thick-films and the challenges for the low cost processing of the thermoelectric microgenerators (TEMGs) are presented and discussed. The TE thermopiles were successfully prepared from oxide-based TE materials, the p-type Ca3Co4O9 (Ca349) and the n-type (ZnO)5In2O3 (Z5I). The Ca349 thick films, fired at 920 °C for 15 minutes, had TE characteristics comparable to the bulk ceramics. However, the Z5I thick film had very low TE characteristics due to poor densification even after firing at 1350 °C causing strong interaction with alumina substrate and sublimation of ZnO, which represents a serious challenge.