Views: 0 | Downloads: 0
In quest of energy efficiency and sustainability enormous amounts of produced waste heat have been completely neglected so far. The thermoelectric devices (TE) offer only viable possibility to exploit it by direct conversion into the electrical energy. The oxide TE materials are attractive for high-temperature applications, chemically stable and also environmentally friendly and non-toxic, made from abundant and low cost elements. However, to compete with the state-of-the art TE materials in the sense of TE figure of merit (zT), energy and cost of their processing, a significant improvement of their zT is required, as well as optimization of the methods for synthesis and processing.
The topic of my PhD research was the development of the promising p-type thermoelectric oxide Ca3Co4O9 (Ca349) ceramics. I studied the influence of starting oxide powders on the formation of the Ca349 compound using solid state synthesis methods. While the same fine grained single-phase Ca349 material was used, I studied the influence of various processing methods on the microstructural features (morphology and size of grains, degree of texturing and density) and TE characteristics of the Ca349 ceramics. Finally I also studied doping the Ca349 compound with WO3, analysing the influence of high valence and heavy W6+ ions on the microstructural features and the TE characteristics.
Use of relatively coarse grained starting powders of CaCO3 and Co3O4 confirmed sluggish formation of the Ca349 compound at temperatures around 900 °C reported in the literature. However, use of fine powders enabled the formation of a single-phase Ca349 already after a single calcination at much lower temperature of 760 °C for 12 hours, which was also beneficial in further processing of the Ca349 ceramics. A mechano-chemical treatment of the same fine starting powder mixture resulted only in its amorphization; however, it enhanced its reactivity resulting in a single-phase Ca349 ceramics after only 4 hours of calcination at 760 °C. Furthermore I studied the influence of different processing methods, some already reported in the literature, modified and also novel not reported yet. It showed that they influence the key microstructural features (shape, size and thickness of grains, degree of texturing and density) differently, affecting the TE characteristics. Fully textured and dense Ca349 ceramics was also obtained; however, contrary to general expectations, modestly textured and porous Ca349 ceramics had comparable electrical conductivity and Seebeck coefficient at about 3-times lower thermal conductivity and hence much higher zT of 0.31 at 600 °C, which is the highest zT reported for pristine Ca349. The results showed the direction and possibilities for microstructural enhancement of the TE characteristics; while indicating possibilities for further improvements beyond currently obtained zT, for its major increase optimised microstructure should be combined also with proper doping.
Doping with WO3 resulted in the formation of solid solution Ca3Co3.88W0.12O9, indicating much lower solid-solubility than previously reported. Incorporation of W6+ into the Ca2CoO3-layers slightly increased the Seebeck coefficient and significantly decreased thermal conductivity; however, due to also significantly decreased electrical conductivity the obtained zT value was decreased in comparison to the undoped sample.