Views: 0 | Downloads: 0
The emphasis of this PhD thesis is on the selective plasma etching of glass-filled polyphenolic composite for improving their various surface properties. Compared to the complementary or competing etch techniques, plasma etching is fast, controllable and does not adversely affect the bulk properties of the material. By changing the feeding gas composition, better control over the etching process and resulting surface chemistry are achieved.
As a primary investigation, the surface of the composite material was modified inside CF₄ gas discharge. The exposure of reactive F and CFₓ plasma species incorporated various carbon–fluorine bonds on the surface, which decreased the wettability of the exposed surface. Along with the plasma treatment, the surface roughness increased as a result of surface polymer removal and consequent filler exposure onto the surface. However, the studies of the aging effects revealed that the hydrophobicity was mostly influenced by the bonding states of carbon rather than the changes in the surface roughness. Further, the dynamic contact angle measurements were employed to enlighten the mechanisms behind the existence of water droplets on the hydrophobic surface. In addition, the effects of surface temperature during the treatment and resulting hydrophilic recovery were considered.
Further, the electrical insulation properties of the polyphenolic composite surface were also improved by the successful removal of the surface polymer inside low-pressure O₂ or gas mixture O₂/Ar plasma. The etching process was optimized by combining plasma diagnostics measurements. The polymer etching rate was mostly connected with the O atom flux onto the surface, which was increased by increasing the degree of O₂ dissociation by Ar addition. This enlightened the role of various plasma species in the etching process. After the surface polymer removal in O₂/Ar plasma, the electrical insulation properties sufficiently increased, which was adequate for the material to be used in commercial devices, according to the available safety regulations. This increase in insulation properties was achieved in a few minutes of plasma treatment. The newly achieved methodology of surface preparation avoided the need of using expensive fillers in composite technology for the fabrication of insulating devices.
The experimental work of this PhD thesis was rounded off with a comparison of selective removal of the surface polymer and the etching rates achieved in various commercially important feeding gases. The highest etching rates were measured inside O₂ plasma compared to N₂, H₂ or NH₃ plasmas due to the high affinity of atomic O species towards the interaction with the carbonaceous polymer layer. By combining spectroscopic methods with various surface analyses, we identified various plasma–surface chemical interactions, which are promising for the fundamental understanding of the surface processes.