Views: 0 | Downloads: 0
More than half a century ago, Christian Anfinsen wrote the first chapter on the process of protein folding. Since then, researchers from different scientific fields have been trying to write further chapters, which would describe the forces that govern the processes of protein folding, unfolding and aggregation. Vibrational spectroscopy is not the most common spectroscopic method for studying the protein structure. Since it enables experimentation with different solutions and detects structural changes in short time scales, this method can significantly complement the information gathered by more conventional methods. The study of short alanine peptides in matrices under inert atmosphere revealed the C7 conformation as the most favorable one in homomeric systems and to a lesser extent the presence of the PPII, β and α conformations. The relative amount of these latter conformations depends on the length of the polypeptide chain. Spectral analysis of short peptides reveals the useful value of the Amide I and Amide III bands, mainly because their spectral areas are independent of the surroundings. Structural changes observed during hydration of the Concanavalin A, Chymotrypsinogen A, Pepsin and Stefin B protein films reveal that hydration stimulates the formation of β structures. Despite the fact that the observed changes are not extensive they are detectable by means of various methods of vibrational spectroscopy. We introduced a technique capable of determining the thickness of protein films, based on the known composition of amino acids in an individual protein and the calibration curve obtained for the case of bovine serum albumin protein films having various known thicknesses. The number of water molecules bonded to a single polypeptide chain as a function of relative humidity was determined. Knowing that vibrational spectroscopy is capable of monitoring small structural changes that occur during the hydration processes, we applied this technique to follow up various conformational changes during the aggregation processes of Concanavalin A and Stefin B. Thus it was found that in a basic environment Concanavalin A forms amyloid aggregates while in an acidic environment it forms amorphous aggregates. For both types of thermally driven processes we followed up the respective structural changes and from the data obtained we defined the spectral markers which discriminate between both types of morphologically different aggregates. In addition to the thermally driven processes we followed up a thermally induced time dependent process of Concanavalin A aggregation at pH 9. All conformational changes were quantitatively characterized by means of the spectral band decomposition method. The process of thermally driven aggregation of Stefin B was monitored at pH 3, 5, 7,5 and 9. At all pH values Stefin B forms amyloid aggregates. The melting point is increasing with increasing pH. Based on the results obtained we proposed a new model capable of describing the process of amyloid fibril formation of Stefin B. This model does not involve complete unfolding of the polypeptide chain, but rather partial restructuring of the α helix and β sheets in a way to allow the formation of cross β sheets, a typical structural element of amyloid fibrils.
peptide vibrational spectroscopy aggregation hydration protein films amyloid fibrils amorphous aggregates Stefin B Concanavalin A