REPOSITORY > RESULTS

Doctoral dissertation

The influence of atmosphere and surface topography of PVD hard coatings on their tribological properties

Author(s): Aljaž Drnovšek (Author), Miha Čekada (Supervisor)

Thesis defense date: 08.03.2017

Organization: MPŠ - Mednarodna podiplomska šola Jožefa Stefana

PID: 20.500.12556/ReVIS-15008

Views: 0 | Downloads: 0

Abstract

Hard coatings have been in widespread use for over 40 years in the industry and the demand for new coatings is still increasing. Hence, the tribological evaluation of the coating in laboratory before the use in real application is very important. The first step to determine the adequacy of the coating for a certain application is by a simple pin on disc tribological test. Such a test allows us to control the parameters in a simple sliding geometry that enables the studies of friction and surface interactions such as tribochemical reactions, generation of wear debris and galling of the counterbody material on the hard coating. These surface interactions influence the coating wear behavior.
During the tribological test the coefficient of friction undergoes several phases. The first one is the running in period in the beginning of sliding. The topography of surfaces in contact has a major influence on this period, since the contact between the surfaces is not conformal. The topography of the sputtered coatings is mostly determined by growth defects which are common in all PVD hard coatings. Growth defects are coating irregularities like nodular defects, craters and
In this thesis the influence of nodular defects on tribological performance of magnetron sputtered coatings is presented. The aim was to examine in detail the tribological processes that occur between the surfaces, one coated with a hard coating and typical tribological counterbody materials. A cycle to cycle approach presented in the thesis allows us to examine the contact even when realistic counterbody material is used. TiAlN hard coating surface was examined by scanning electron microscope on regions of selected nodular defects after each cycle of sliding against alumina and softer steel (100Cr6) counterbody. In the first few cycles breaking and powdering of nodular defects was observed. This generates a large amount of hard abrasive particles. The running in process when using alumina counterbody is relatively slow and reflects in a longer running in period in comparison to the softer 100Cr6 counterbody. The initial interactions of nodular defects with steel counterbody have not yet been reported. The revealed mechanisms consist of micro cutting the softer counterbody and eventually the generation and formation of tribological film patches on the sites of nodular defects. Distinct differences in wear mechanisms between the two counterbody materials in contact are presented.
As the nodular defects wear out, the running in period ends and the transition to the second period, the steady state period begins.
The tribochemical reaction between the surfaces is the prevailing process which determines the friction and wear behavior in the steady state period. To test this pin on disc experiments with several conventional hard coatings, such as TiN, TiAlN and CrN and more advanced hard coatings, namely CrAlN and CrVN were performed in different atmospheres with alumina counterbody. Test results performed in ambient air atmosphere, as a reference, and in inert (N2) and oxidizing (O2) atmosphere are reported. A detailed SEM/FIB and EDS analysis of wear tracks and wear debris is presented in the thesis. Results show that the coefficient of friction and wear behavior of the coatings sliding against alumina is severely influenced by the change of atmosphere. Tests showed different behavior such as low friction and low relative wear due to the lack of tribological oxidation in nitrogen atmosphere and changes in friction coefficient due to different surface chemistry invoked in pure oxygen atmosphere. Fish scale like features on novel advanced hard coatings were found in oxidizing atmosphere.
At the end a comparison in tribological behavior is presented based on the experiments on the conventional and advanced coatings.

Attachments

Cite this work