REPOSITORY > RESULTS

Doctoral dissertation

Thermoelectric materials based on doped strontium titanates

Author(s): Marja Jerič (Author), Miran Čeh (Supervisor)

Thesis defense date: 24.11.2016

Organization: MPŠ - Mednarodna podiplomska šola Jožefa Stefana

PID: 20.500.12556/ReVIS-15024

Views: 0 | Downloads: 0

Abstract

Increasing concern for the environment promotes the search for alternative sources of energy that would be ecologically sound. In this sense, waste heat produced as a side effect of machines operation could be used as a power source by employing thermoelectric devices. Thermoelectric generators are namely able to convert temperature gradient directly into electrical voltage by the Seebeck effect.
Up to date, most used thermoelectric materials have been metal-based alloys, which however suffer from high temperature instability, when they are not properly protected. Their constituents are frequently also highly toxic. In mid 90’s of the 20th century scientists' attention was drawn towards oxide-based materials, which showed promising power factors and high temperature stability. Since then, many oxide materials have been studied, such as ZnO, Ca₃Co₄O₉, CaMnO₃, and SrTiO₃. In spite of all the efforts, the thermoelectric figure of merit of oxide-based materials remains low. It is commonly accepted that the drawback of oxide-based materials arises from the high thermal conductivity originating from the crystal lattice vibrations (phonons).
PhD work, presented in this thesis consisted of synthesis of thermoelectric materials based on Nb-doped SrTiO₃ (STNO), their microstructural characterization and physical properties measurements. In order to study the effect on the materials reduction, STNO was sintered in different atmospheres. The results showed that the reducing atmosphere strongly affects the reduction of Ti⁴⁺ into Ti³⁺ of STNO and the formation of oxygen vacancies.
Secondly, STNO microstructure was modified by introducing phonon barriers in order to lower the lattice thermal conductivity. Planar faults of the Ruddlesden–Popper (RP) phases are well-known structural defects in the SrTiO₃ system and were therefore chosen to be introduced in the STNO. Two approaches were employed: addition of RP-type platelet seed crystals (Seeded STNO) or addition of excess SrO or CaO (STNO:SrO or STNO:CaO). RP-type seeds were made by the molten salt synthesis and characterized in a separate study.
Microstructural investigations of Seeded STNO showed anisotropic grains with up to 100 μm planar faults in a matrix of large isotropic grains, which contained no faults. Addition of excess SrO resulted in numerous planar faults running in all directions. STNO:CaO showed a microstructure of isotropic to slightly anisotropic grains with planar faults.
In comparison with STNO, prepared with the same synthesis conditions, the thermal conductivity of Seeded STNO was only slightly reduced, however, the electrical conductivity showed a metallic behavior. On the other hand, the thermal conductivity was significantly reduced in STNO:SrO and especially in STNO:CaO. In this regard, adding excess CaO has proven to be a promising method to lower thermal conductivity of STNO. On the other hand, addition of seeds resulted in enhanced electrical conductivity and consequently the highest thermoelectric figure of merit of the studied microstructures.

Attachments

Cite this work