Views: 3 | Downloads: 0
Glass wool is one of the most widely used insulation materials and is specially known for its excellent thermal insulation properties. The main benefit of the glass wool production process is the use of a waste glass as a base material to produce a high quality insulation material. Glass wool is commonly used for thermal and sound insulation in buildings, resulting in economic, health and environmental benefits for the society. The glass wool production process is highly complex, consisting of several different production phases. Adequate understanding and control of each phase is required in order to optimize the properties (e.g. thermal conductivity, homogeneity and mechanical properties) and production costs of end products. Glass fibre distribution in the end product must be as homogeneous as possible to obtain optimal thermal conductivity properties. With optimal glass fibre distribution, the consumption of raw materials and energy is minimized, while also minimizing the thermal conductivity of end products. Due to the fact that the glass wool production process is affected by many different parameters, the correlation between process variables of fiberization machines and collecting chamber and the end product quality is highly complex.
The proposed PhD thesis is in agreement with requirements of the industrial production process of glass wool. New knowledge will enable improved understanding of the process of glass wool layer formation and fibre density distribution in the collecting chamber. The modelling procedure may be applied in the production process where the main expected benefit is an improvement of the end product properties and a reduction of waste and second-class products quantity. Experimental and numerical models for fibre properties and quality of final product are also provided.
The process of fibre layer formation and fibre distribution in the forming chamber can be optimized and controlled by measurement and control of several selected process parameters.
We have formed the following two hypotheses:
• Based on measurements of the volume flow rate of air, volume flow rate of gas, spinner rotational speed, mass flow rate of melt, air pressure and melt temperature, a model for prediction of the glass wool fibre thickness can be formed.
• Reliable prediction of the transversal fibre density distribution in the forming chamber and in the end product can be achieved using parametric model based on the same set of input variables, allowing for an improved process control.
In Chapter 2 a model which allows glass wool fibre thickness prediction is presented and the first hypothesis is addressed. Fibre thickness is an important parameter of glass wool quality as it influences the local thermal insulation properties (thermal conductivity) and significantly affects the fibre density distribution in the collecting chamber.
In the experiment with a model spinning machine, we analysed the normalized standard deviation of the optical intensity (σGn) of acquired visualization images, local fibre accumulation rates (ψ), and dimensionless distance between the fibre layer centre of gravity and centre of accumulation grid (δ). Multiple regression models for δ and σGn have shown an important effect of the suction flow, coaxial and tangential blow-away flows as well as fibre deposition time on the fibre layer properties. Also, these models are in a good agreement with measured values of δ and σGn and also with the estimated fibre accumulation rate. Regression models and qualitative analysis results improve the understanding of the fibre transport and the fibre layer formation process, leading to new possibilities for process monitoring and automation. The topic is presented in Chapter 3 and is addressed in the second hypothesis.
In Chapter 4 a model is presented with correlation between air suction flow velocity on the bottom of the collecting chamber and glass wool transversal fibre density distribution on the final product. An assumption was made that the glass wool quality can be improved by increasing the uniformity of the air flow velocity distribution, and has been confirmed by analysis of acquired experimental data. The results of velocity measurements in the collecting chamber will also allow for a more precise process control.
Based on the key parameters that influence the transversal fibre density distribution in a layer of glass wool and with the aid of density measurements performed by the X-Ray device we have formed the main regression model. It can be used by the glass wool line operator as a guide for setting the operating parameters instead of relying solely on past experience. The topic is presented in Chapter 4 and is addressed in the second hypothesis.