Views: 1 | Downloads: 0
In this thesis we have focused on three micromachining (in this case, microforming) methods with fundamentally different physical backgrounds. All three methods are already implemented and optimised in industry for very specific applications in the security-printing field. They are applied to engrave the security features on lamination plates and intaglio printing plates. The lamination plates are used for identity-card production and the intaglio printing plates are dedicated to printing the tactile security images for banknotes, passports, etc. The first micromachining method is scratching, where a needle-tip is uniformly slid over the workpiece surface while the material is cold formed. The main engraving parameters are the needle-tip radius, the tool load, the transverse tool velocity and the number of tool passes. The second micromachining method is micromilling, where a part of the workpiece material is removed by a cutting tool (the micro endmill tool). The relevant process parameters are the tool geometry (tool radius), the cutting depth, the rotation speed and the tool transverse speed. Both the tool material and the lubrication play an important role in both methods, but they were not analysed in more detail. Laser engraving is the last micromachining method, where the laser-beam energy is used to locally heat the workpiece material, possibly up to the melting point, or even to the boiling point. With sufficiently high energy the material is removed from the target area as a vapour, or in some cases plasma can appear. The process parameters are the pulse frequency, the average output laser power, the laser-beam scan speed and the laser-beam focus.
Common to all three methods are the impacts of four characteristic process parameters and their correlations with the geometrical variables (width, depth, cross-sectional area and roughness), and the hardness on the groove cross-section. The material used in this work was a thick cold-rolled stainless steel AISI 304.
The surface-profile analyses were carried out using optical microscopy and profilometry. The scanning electron microscopy (SEM) and energy-dispersive X-ray spectroscopy (EDS) were used to obtain the basic data of the microstructure and the chemical composition of the material at the groove cross-section. For the evaluation of the hardness, a cross-section was prepared using a standard metallographic preparation and the measurements were performed at a pre-defined mesh. The hardening was modelled as a Gaussian in both directions: perpendicular and parallel to the surface.
The evaluated results were the input data for the statistical analysis. All three experimental methods were conducted using four process parameters at three discrete values. In this case the design of experiment (DoE) and L27 (34) Taguchi standard orthogonal array were used for the experimental design. In addition to the DoE, the applied statistical software “Design-Expert 8.0” is supported by the response-surface methodology (RSM) and the analysis of variance ANOVA. The latter enabled us to identify the effect of each process parameter and their interactions in terms of the responses.
In the case of scratching we obtained robust statistical results, which show us that the performed model for the geometrical responses can be reliably predicted. The spread of the hardening can be predicted with a somewhat lower probability, while the statistical results for hardening intensity and surface roughness are too low to be reliably predicted. However, the results gave us some guidelines.
In the case of micromilling, the statistical results for the surface roughness were less significant, but still good enough so that the geometrical variables could be interpreted with a sufficient probability.
The resulting statistical results for the laser micromachining are good and significant. With reliable performed models we can predict all the geometrical responses with a high probability, except for the surface roughness.