Views: 2 | Downloads: 0
Ferromagnetic nanostructures (nanowires-NWs and nanotubes-NTs) have attracted
considerable interest due to their unique properties and potential applications, ranging
from the magnetic storage and recording devices, sensors and logic application. The
fundamental understanding about the magnetic domain structure and magnetization
reversal mechanism in a nanostructure is key to utilize them in possible applications. The
main parameter that influences these magnetic properties of nanostructures is the effective
anisotropy which further consists of a shape and a magnetocrystalline anisotropy (MCA)
for most of the nanomaterials. Therefore, fine tuning of the effective anisotropy requires a
control over involved anisotropies, thus providing the ability to tailor the magnetic
properties for specific applications. For instance hcp, Co-Pt nanostructures with high MCA
can be building blocks for racetrack memory (or domain-wall memory) devices due to their
ability to contain a large number of domains, whereas, Fe-Pd NWs with a high shape
anisotropy can be useful for logic devices.
In this thesis, we synthesized and characterized Co-rich Co-Pt nanostructures by
potentiostatiostatic electrodeposition technique, into nanoporous of anodic aluminum oxide
(AAO) as well as polycarbonate (PC) membranes with diameter ranges from 15-200 nm.
First we focused on the synthesis of relatively new complex magnetic structures with a
tube-wire segments. The current transient (I-t curve) monitored during the deposition
procedure allowed us to distinguish between the NT and NW formation during the
electrodeposition synthesis, thus we present ground breaking results to fabricate Co-Pt
nanostructures with a tube-wire morphology. For the first time we studied the
magnetization reversal mechanisms in these complex Co-Pt nanostructures. We found that
the tube segment always reverses its magnetization first, through nucleation and
propagation of a vortex domain wall, whereas the wire segment magnetization follows via
nucleation and propagation of a transverse domain wall. In order to further explain the
results, micromagnetic simulations were performed that confirmed our experimental
results. Such nanostructures are attractive from the application point of view due to their
ability to control the motion of the magnetic domain wall. (See Chapter 3)
According to the phase diagram, Co-rich Co-Pt can crystalize in a hcp crystal structure,
known to be highly anisotropic, with its magnetic response being dependent on the hcp caxis
orientation, which is the magnetization easy axis in this system.
The results showed that the crystal structure of the Co-Pt NWs depends on Co content
and it was found that with Co content higher than 80 at% only hcp, 60-80 at% intermixed
hcp and fcc and below 60 at% only fcc crystal structure was observed. The crystallographic
orientation (texturing) analysis showed that c-axis [001] of hcp phase and the [111] of fcc
phase are pointing almost perpendicular to the NW long axis. These observations allowed us to understand the perpendicular easy magnetization axis of the Co-Pt NW arrays. (See
Chapter 4, 5, and 6)
In order to determine the effective anisotropy in the Co-Pt NW system, we performed
analytical calculations and compared them with the experimental measurements of the
angular dependence of the coercivity (ADC) for Co-Pt NWs. From the good agreement
between the two, we were able to determine the effective anisotropy constant (Keff=2.6
104 J/m3) for Co-Pt NWs (diameter~200 nm) which further helped us to explain the
magnetic properties of such NWs.
It is known that the in-plane magnetostatic interactions between the Co-Pt NWs in an
array can be responsible for perpendicular easy axis. To determine the parameter
influencing the perpendicular easy axis orientation, we performed first-order reversal curves
(FORCs). We found that there are weak magnetostatic interactions between the Co-Pt
NWs, thus, perpendicular magnetization easy axis is due to hcp crystal structure with
strong texturing of c-axis perpendicular to NW long axis. The complex FORC diagrams
were obtained for Co-Pt arrays in AAO membranes which is related to the variation of the
hcp crystal orientation. The ferromagnetic resonance (FMR) results confirmed our
hypothesis, where we obtained large linewidth connected to the inhomogeneity in hcp caxis
orientation in Co-Pt NWs arrays in AAO membranes. The information about hcp caxis
orientation is crucial for application point of view as it significantly influences
switching-field distribution and the magnetic domain structure of such NWs. On the basis
of these information we proposed the “oblivious growth” of Co-Pt NWs, related to small
fluctuation in pore diameter and pore shape first time. From the FMR measurements we
were able to estimate the effective anisotropy constant (Keff=4104 J/m3) which was found
to be very close to the observed values from ADC for Co-Pt NWs, confirmed the validity
of both methods. (See Chapter 5)
The results obtained from interacting Co-Pt NWs array accentuate that the
characterization of an individual NW can be washed out, thus it is important to gain
magnetic information on an individual NW structure. Thus, we separated Co-Pt NWs from
their membranes and studied their magnetic domain structure with magnetic force
microscopy (MFM). In hcp Co-Pt NWs (daimeter~200 nm) with c-axis pointing
perpendicular to NW long axis a rapid alternation of pairs of diametrically opposed darkand-
bright contrasts along the lengths of the NWs was observed. Such contrast can be
originated by a competition between the shape and MCA and can be interpreted as
transverse (TS) and/or longitudinal stripe (LS) domain structures in NWs. It is important
to stress out that such magnetic domain structures in high perpendicular anisotropic NWs
are under intense research and conflicting in some cases. We have found that both domain
structures (TS and LS) have the lowest energy state when the strong MCA is acting
perpendicular to NWs long axis. In case of acute angle of hcp c-axis w.r.t to NW along
axis the vortex domain structure became favorable. Our conclusion is based on a large
number of MFM experimental results compared with micromagnetic simulation (NMAG).
(See Chapter 5 and 6). For the comparative purpose the magnetic response of ferromagnetic Fe-Pd NW arrays
and individual Fe-Pd NWs are presented. Unlike Co-Pt NWs we observed that equiatomic
Fe-Pd NWs show a single domain behaviour with the magnetization easy axis along the
long axis. Square hysteresis loop was obtained for a single Fe-Pd NW, however strong
magnetostatic interactions was observed to be responsible for sheered hysteresis loop in
arrays, information obtained is critical for such applications. (See Chapter 7)
This study shows that the magnetization distribution and magnetization reversal in Corich
Co-Pt NWs is driven by the MCA and it is tuned by the crystal structure. On the
other hand in low MCA materials like fcc Fe-Pd the shape anisotropy is the governing
factor. Moreover, a complete control over these anisotropies (including hcp c-axis) is
paramount to tune the magnetic properties of such NWs for possible applications such as
racetrack memory devices or as structural components in micro- and nano-electronic
devices.