Views: 3 | Downloads: 0
Fabrication and design of functionalised coatings on metals is attractive because of the wide range of applications and consequently the large impact such materials potentially have. In my work I evaluated the possibilities of hydro- and solvothermal treatment along with simple post-processing methods on metallic aluminium and zinc to obtain new materials with novel or improved properties, such as self-cleaning, superhydrophilicity, superhydrophobicity, photocatalytic degradation of organics and dielectric properties. These improved properties were achieved by the formation of nano- and micro-sized coatings of titanium dioxide (TiO2), zinc oxide (ZnO) and aluminium oxide hydroxide – boehmite (γ-AlO(OH)) that were prepared in general-purpose autoclaves at temperatures up to 200 °C in deionised water, ethanol and isopropyl alcohol with precursors for Ti (titanium(IV) isopropoxide) and Zn (zinc nitrate hexahydrate, zinc acetate dihydrate) ions. Two and three-layer structures were hydrothermally prepared on aluminium sheet, either with 1.5–2 μm thick boehmite layer or with boehmite and nanolayer of photoactive TiO2. Dielectric response was measured on the aluminium/boehmite system and was found to be very stable with ε' values in the range from 5.5 to 6.5 over broad temperature (275–350 K) and frequency (1 kHz–1 MHz) ranges. TiO2 coated aluminium substrates were characterised for photocatalytic activity towards 10 ppm caffeine solution. Hydrothermally prepared TiO2 powder achieved comparable degradation rates to Degussa P 25 reference. As expected, immobilised TiO2 samples achieved lower degradation rates than the powder sample, but offer great improvement in catalyst handling, secondary pollution by erosion of photocatalyst into the environment while still retaining comparable efficiency. Hydro- and solvothermal treatment on zinc results in a formation of a diverse range of ZnO morphologies depending on synthesis conditions, solvent and precursor used, and additives. 50–100 nm thick ZnO needles, growing from the same base, form hedgehog-like structures that significantly increase the surface of the substrate and offer the base for preparation of superhydrophobic materials in conjunction with dip-coating in fluoroalkyl oligosiloxane. I showed that such superhydrophobic zinc surfaces exhibit no adhesion of E. coli bacteria.